MainPage » » 2007 Dodge Nitro R/T transfer case removal disassembly

2007 Dodge Nitro R/T transfer case removal disassembly

1. raise the vehicle. Warning: do not let hang cardan shafts attached at the end. Joint damage may result. 2.3. 4.5. Remove the front and rear propeller shafts. Refer to disposal. Transfer support with Jack. Remove the Rear crossmember and skid plate, if applicable. Disabling a case deflector hose (4). Cm. Fig. 2.6. 7.8. 9.10. Disconnect the wiring connector from the shift motor, if necessary. Support for transfer of the case to the transmission Jack and secure with chains. Remove the nuts (2) giving a transfer case (1) gear box (3). Pull the transfer case and Jack turned to disengage transfer case.


Remove the transfer case out from under the car. Disassembling the case transfer case to transmission position MP140 shallow drain pan. Remove the drain plug (2) and drain the grease. 2. using the bracket C-3281 (1), remove the rear output flange nut. 3. remove the rear output shaft flange (1) out of the main shaft (2). If the flange is difficult to remove manually, remove it with a separator or standard bearing two jaw puller. Be sure to eject the tool securely positioned on the flange. Download


Posted in . Bookmark the permalink. RSS feed for this post.
Powered by Blogger.

Search