MainPage »
Chrysler
»
DIAGNOSIS AND TESTING - WASHER SYSTEM CHRYSLER
DIAGNOSIS AND TESTING - WASHER SYSTEM CHRYSLER
Whenever a windshield washer malfunction occurs,
first verify that the washer pump connector and the
multi-function switch, front wiper/washer switch connector
is properly connected before starting diagnosis
and testing. Also check the rear wiper/washer switch
connection. Refer to WASHER SYSTEM TEST table.
FRONT WASHER NOZZLE
REMOVAL
(1) Open hood.
(2) Remove the underhood, rear hood silencer pad
fasteners.
(3) Disconnect the washer hose from the underside
of the front washer nozzle.
(4) Lower hood down.
(5) Using a plastic body filler spreader or equivalent
(credit card), gently place it underneath the
front of the washer nozzle. Be careful not to damage
the hood seal underneath the nozzle (Fig. 6).
(6) Rock the nozzle back and forth slightly to
release it from the hood panel.
INSTALLATION
(1) Place the nozzle into hood opening and snap
into place.
(2) Open hood.
(3) Connect the washer hose to the underside of
the washer nozzle.
(4) After connecting hose, check for proper system
function and to assure leak free connections by actuating
the front washer system switch from inside of
vehicle.
(5) Install the underhood, rear hood silencer pad
fasteners.
(6) Close hood.
(7) Verify system operation.
Posted in
Chrysler
.
Bookmark the
permalink.
RSS feed for this post.