MainPage »
Chrysler
»
FRONT WINDSHIELD WIPERWASHER SWITCH LOCATION
FRONT WINDSHIELD WIPERWASHER SWITCH LOCATION
1 - TURN SIGNAL CONTROL STALK 5 - CANCELLING CAM
2 - HAZARD WARNING SWITCH 6 - PANEL DIMMER/INTERIOR LIGHT SWITCH
3 - WINDSHIELD WIPER/WASHER CONTROL 7 - EXTERIOR LIGHTING CONTROL/FOG LAMP
4 - WINDSHIELD WIPER/WASHER SWITCH RETAINING SCREWS.
FRONT WINDSHIELD WASHER SYSTEM
This vehicle is equipped with an electrically operated
windshield washer pump. The washers are operated
by a switch in the multi-function switch control
lever (Fig. 1). The lever is located on the right side of
the steering column.
The electric pump assembly is mounted directly to
the reservoir. A permanently lubricated motor is coupled
to an impeller type pump.
The pump and reservoir
are serviced as separate assemblies.
REAR WINDSHIELD WIPER SYSTEM
The driver controls an electrically operated intermittent
rear wiper system with the switch located on
the instrument panel accessory switch bezel. The
rear wiper is controlled by ignition switched battery
current through a fuse in the fuse block, and will
operate only when the ignition switch is in the Accessory
or ON positions.
The intermittent rear wiper system allows the
driver to select an intermittent wipe mode. The intermittent
wipe mode delay time has a fixed delay interval
of about four seconds between sweeps. This
system also has a wipe-after-wash feature that operates
the rear wiper for as long as the washer pump is
energized, then provides about two additional sweeps
of the wiper after the washer pump is de-energized.
The rear wiper motor module operates on a separate
non-switched battery current feed through a
fuse in the fuse block.
Posted in
Chrysler
.
Bookmark the
permalink.
RSS feed for this post.