remove noise isolation of the Pan in the engine compartment. 2. remove the air channel tube between the turbocharger and charge air cooler. see Figure 1. Air feed pipe is located at the bottom right of the cross article. 3. marking direction of rotation of the serpentine drive belt. Move the serpentine belt tensioner device as shown on the release of the tension of the belt. see Figure 2. protected tension, with the help of floating around. 18 mm (4,5 mm) x 2.2 "(55 mm). see Figure 3. remove the serpentine drive belt. remove the serpentine drive belt tensioner. Note: for vehicles without front, cleaning system, can be used connecting rod support (3090) to provide tension. 4. rotate the crankshaft so that no. 1 cylinder is TDC of the compression stroke. to ensure that they are aligned to the TDC marks on the flywheel and bellhousing. see Figure 4 or Figure 5. 5. to remove expansion tank coolant and set aside. label all vacuumhoses for re-assembly reference and disconnect the vacuum hoses from the evaporative fuel filter. Disconnect the vacuum hoses in the valve body. 6. remove the upper timing belt cover. see Figure 6. 7. coupling maintenance engine bridge (10-222a) with bracket (10222) and retainer engage with right, lifting eye bolt, located in the cylinder head. raise the engine slightly to remove weight from the engine the month. the engine may be supported by the lower floor with Jack. attention: the engine mount is attached with a torque to yield-bold. crankshaft-Walt Disney Center bolt also has bolt torque to yield. These bolts must be replaced if they are razhlabva may be released or removed. 8. remove the bolts from the engine mount Assembly in the time belt end of the engine. remove the mounting of the engine. 9. Remove 4 crankshaft clamp socket-head screws. remove the crankshaft pulley. It is not necessary to remove the bolt on the crankshaft roll Center. 10. removal of low and medium time belt covers. Remove the engine bracket from the engine block. see Figure 7. If reusing the old timing beltmarks timing belt with an arrow to display the initial direction of rotation. 11. screw, tensioning bolt (t10092) or M5 x 55 x 1 stud in timing belt tensioner bracket.
Download
