MainPage » » 2002 Land Rover Freelander automatic transmission/Transaxle: service and gearbox repair-KV6-NAS models

2002 Land Rover Freelander automatic transmission/Transaxle: service and gearbox repair-KV6-NAS models

Tie back cover in the upright position. Disconnect battery Earth lead. Remove audio bonnet. 5.6. 7.8. HO2S multiplug version from the support bracket for LH camshaft cover, unplug multiplug. Raise the vehicle on a lift. Remove rear beam. Remove RH catalytic converter. 9. Remove 2 nuts securing the front exhaust manifold. 10. release and disconnect after catalyst HO2S multiplug. 11. release post catalyst HO2S wiring from clips. 12. remove the bolt securing the front tube bracket and remove the front tube. Discard gasket. 13. Remove 3 screws securing LH shield and splash shield. 14. the release clip lead HO2S cylinder blocks. Remove 4 nuts securing multiple cylinder head, remove and discard gasket backpressure. 15. Drain liquid from the IRD. 16. Drain transmission fluid. 17. FitLRT-54-026 in common inboard RH axis unit. 18. Using the appropriate lever release drive axle from IRD. 19. with the assistance of attraction hub to the outside and release from IRD unit spindle. Caution: care should be taken not to damage the oil seal when you remove the drive shaft from IRD. Caution: to avoid damage to or a joint gaiter, does not allow shaft to hang in common. 20. Remove LRT-54-026 from RH drive axle inboard joint. 21. Remove and discard the drive shaft circlip. 22. remove the bolt securing the lower engine mounting bracket fixed to the tank. 23. Remove lower engine steady, noting that ' TOP ' mark on engine steady anxious faces. 24. reference mark propeller front axle for reconstruction. 25. Subtract 6 nuts and bolts securing the propeller shaft flange drive IRD. 26. release the propeller axis from IRD flange and drive shaft to cultivation. Caution: care should be taken to support common Tripode when removed from the IRD. To avoid damage to steel, gaiter or joint must not be extended completely or rejected. 27. Disconnect hose separator from IRD housing. 28. Place container for collecting coolant escape. Download


Posted in . Bookmark the permalink. RSS feed for this post.
Powered by Blogger.

Search