MainPage »
Toyota
»
2005-2006 Toyota Tacoma clutch pedal FEEL better
2005-2006 Toyota Tacoma clutch pedal FEEL better
Introduction, some customers may complain to one of the following conditions is true: S grinding during changer s difficulty in attracting or Edition 4WD low s uncomfortable foot or leg position with the clutch pedal fully depressed the clutch pedal Assembly and the carpets were changed to improve the clutch pedal feel and exploitation. Repair procedure for a carpet modification 1. Remove the front door scuff plate LH. Disconnect and remove the front 9 claws door scuff plate. 3. remove the cowl side trim Board LH. A. remove the clip. B. separation 2 clips and remove the cowl side trim Board. 4. Cut the carpet felt backing (padding). A. turn the left front floor carpet. B. Mark the position where the foam front deck before deleting. Note: the S Word Pad color of previous front (P/N 58571-04060): cream yellow s color from the new front floor pad (P/N 58571-04070): black c. remove front floor foam pads on the rear floor carpet. D. cut felt, laying on the back of the carpet floor without cutting a rug with a knife carpet, adjusted only to the depth of the felt pads. Cut the felt, the fields in the form below. 5. replace brake pads front floor. A. Clean any residues from the back of the carpet, where the word pad was located. B. attach a new front floor pad rear floor carpet. C. confirmation that square section raised on the foam is in the same position as the original to ensure proper alignment. 6. cut the insulator Panel dash. Dash insulator Panel 7. Return of the carpet in his former post. 8. go to the repair procedure, (B) replace clutch pedal. Replacement clutch pedal 1. A record of all the presets radio before. 2. disconnect the negative (-) battery cable terminal. 3. remove the sub-assembly clutch pedal. Note: Steps 3A, 3B, can be omitted if the procedure to repair a just completed. A. Remove the front door opening trim LH (scuff plates). B. Remove the cowl side trim Board. C. remove a toolbar complete Lower unit No. 1. E. delete the spring turnover (compression). F. remove the bolt Assembly building dashboard. G. delete the sub-assembly clutch pedal. a. remove the bolt and nut. b. remove the clutch pedal clutch pedal support. here Download
Posted in
Toyota
.
Bookmark the
permalink.
RSS feed for this post.