Note: illustration shows left side. on the right side is derived from this. 1-cable for the release of the lock inside door handle 2-cable for the release of the lock of external door handle 3-screw quantity 2 to support locking the door Interior 18 nm 4-for removal of locking the door and install-> locking the door and installed 5-coverage does not belongs to locking the door delivery envelope, with the retention of sections for locking the door 6-mounting bracket and installed-> bearing skobai installed 7-torx screw, 8 – Beck 9 – the lock cylinder housing only the drivers only one Corps was installed on the passenger front side and installed-> housing, download and 10-cover cap for dwelling on the lock cylinder to lock cylinder housing with three retention tabs 11-key to change the battery-> battery key radio frequency with remote management (folding)- Overview of the Assembly adaptation of new/additional keys of the remote control and block-> adaptation of keys with remote management of radio frequencies 12- handle the doors with backing plate and installed-> door handle, remove and install 13-backup is a component of the door handle 14-torx screw 4.5 nm homes, removed and Note: remove and install is described only for the hull. Remove and install the lock cylinder is obtained from this. remove the pry in coating (fig. 88, point 2) by the front door. Figure 100: housing, remove and install the generous consent of Volkswagen Group United States of America, including pry, Cap cover to the pin-1-. Pull door-2 – in – the direction of the arrow-handle and otvintite bolt-1-until it stops using the socket wrench t10072. removal of housing-3-. installation of insert, accommodation – 3-in right angle in bearing bracket-arrow-door handle-2-. handle-2-door must connect with a slight neck plate. Now you can install screw-1-in bearing bracket, using the socket wrench t10072. door handle-2-engage again in the Corps – 3 – with many sound click. Note: during the installation, must maintain the Corps on the plate for the door. Handle of the door is slightly against the facing of the door. further installation is in reverse order of removal. then function test should be carried out with the door open, since the door cannot be opened if the release is not properly adjustment or cut contains the door handle, remove and Note: remove and install is described only to handle of the door. Remove and install the handle on the left door is derived from this.
Download
