MainPage » » 1998 Toyota truck Tacoma extra cab 2Wd control Assembly removal and installation

1998 Toyota truck Tacoma extra cab 2Wd control Assembly removal and installation

1. remove the following parts: end of a. b. bottom panel glove compartment door c. lower panel complete with no. 2 2. Final panel remove cluster a. Remove key, A/management of c. b. Pull the enemy. C. Remove heater control plate. D. Remove 2 screws. E. using a screwdriver, remove the 4 mounting clips and the Panel is downloaded, then unplug the connector. Tip: Tape the tip of the screwdriver before use. 3. disconnect the cables Hater control tip: After connection, adjust the control cables. 4. to remove all control of heater remove 2 screws and remove the heater control Assembly, and then disconnect the connector. Installation of the installation is in reverse order of removal.


Tip: after the installation, set the heater control cables. A. mounting set control enemy under the following conditions: 1. the placement of the heater control Assembly in the "Cool" position. 2. "face" position 3 of dialing mode control . Temperature control dial for "Cool" position (b). set air intake cable. Pull my relationship of control as "Cool" position, connect cable and clamp bolt. Tip: Locking Pliers, lightly pressing on the outside of the cable in the direction as shown in the illustration. C. adjust the arrangements for power management. Pull my relationship of control as the "face" of the position, connect cable and clamp bolt. Tip: Locking Pliers, lightly pressing on the outside of the cable in the direction as shown in the illustration. Download1998 Toyota truck Tacoma extra cab 2Wd control Assembly removal and installation


Posted in . Bookmark the permalink. RSS feed for this post.
Powered by Blogger.

Search