() removal of external Grill plastic insert. remove the five (5) bolts from the grill. (Figure 2-1) (b) apply 1 7/8 "(48mm), mylar tapes are external bracket locations. (Figure 2-2) (c) open hood. attach external brackets using the nylon insert. (Figure 2-3) (d) to remove the 6 nuts in the grill to Hud locations. (Figure 2-4) (e) once the locks are removed from steps 2 (a) and 2 (d), Grill naturally must cause a gap at the top of the lid (Figure 2-5). If you need additional permission, slightly pushed the lattice to create a larger space. to account not to push extremely from lattice or outboard clips (not visible) can switch (Figure 2-6). (e) wash thoroughly. apply 3 mylar strips on the Hood and Grill, leave enough overlap to cover Hood. 43 "(1092mm) tapes to the centre section and add 4" (102 mm) pieces to cover the remaining area of the lid. (Figure 2-6) (g) gently slide shield spot and Center.
make sure that the shield is completely seated (Figure 2-7). If you need additional permission, slightly pushed the lattice to create a larger space. to account not to push extremely from lattice or outboard clips (not visible) can switch (Figure 2-6). Insert the screw through the center of the grill and Grill shield (Figure 2-7). (h) retighten all screws grille. (Figure 2-8). torque = 52 in-lbf (i) attach external brackets to cover with the aid of machine screws. (Figure 2-9) (j) to replace the bolts and replace the front Grill Grill plastic insert. (Figure 2-10) (k) remove masking from Hood protector. DownloadTundra Hood protector installation of 2007 Toyota
