MainPage » » Volvo V70 Xc Awd oil pan removal and installation

Volvo V70 Xc Awd oil pan removal and installation

removal and installation 1. before servicing the vehicle, refer to the section on safeguards. 2. drain the engine oil. 3. remove or disconnect the following: air intake Assembly oil with other Assembly right front wheel and inner fender liner splashguard 4 engine. remove the bolts for the oil cooling system and close the system side. 5. remove or disconnect the following: reduce the tube for the air of fee, if equipped pressure hose and return hose, starting from the power steering pump power steering hose bracket and move to one side additional drive belts a/c compressor oil pan to install: 1. install or connect the following: new o-rings for oil pan oil pan and tighten the bolts as follows: a. tighten bolts 123 and 4 to 24 inch lbs. (3 nm) b. tighten bolts to 18.5 ft lbs. (25 nm) and then to 35 ft. lbs. (45 nm) c. tighten all bolts to 13 ft. lbs. (17 nm). start of transmission and work forward in pairs. oil cooling system using new o-rings a/c compressor accessory drive belts pressure of oil and return hoses and hydraulics pump engine splashguard inner fender liner oil with other wheel air intake pipe 2. Start the engine and check for leaks. Fig. oil pan bolt identification-2005-06 s40/v50/c70 models oil pan bolt identification-2005-06 s40/v50/c70 models inline 6-cylinder engines is drained remove engine oil or disconnect the following: 1. oil with other pipe, 2. Turbo charge air tube, if equipped 3. Turbo air intake pipe, if equipped raise and support engine. remove or disconnect the following: lower engine cover air barrier in front of the front wheel oil filter lower ball joints nuts anti-roll bar links of anti-roll bar bolt right axle Center steering front engine mounting bolts from the torque rod, including support in the sub-frame wheel spindles


Download


Posted in . Bookmark the permalink. RSS feed for this post.
Powered by Blogger.

Search