MainPage »
Toyota
»
2007 Toyota Tundra mounting kit installation instructions
2007 Toyota Tundra mounting kit installation instructions
Note the instructions for installation: for easier mounting and installation, vehicle and all snowplow components must be of smooth, level, hard surface, such as concrete. 1. on the side of the driver of the machine remove the remote clip securing the plastic bumper cover to start the dish. keep the knee to reinstall if the plow is removed. then fold the outermost of the plastic bumper cover for easier pushplate installation. 2. trim the splash Pan, as shown for easier pushplate installation. 3. Repeat steps 1 and 2 on the passenger's side. 4. on the driver's side of the machine remove the tow hook clasps and hook for towing. maintain a tow hook to reinstall if the plow is removed. keep the locks for reinstallation of the next step. 5. attach the driver's side to the frame of the pushplate truck, using the original latches hook towing. tighten hinges, so that the pushplate can be firmly against the bottom of the frame, but not fully reinforced at this time. 8.4-7 of the steps on the side of the machine is repeated. 9. to install the cross bar with four 1/2 "x 1-1/2" cap screws and 1/2 '' locknuts. hand tighten fasteners. 10. check connecting hand distance of 29-1/8 "+ 1/8". If the connecting arm distance is not within the 29-1/8 "+ 1/8 '', then loosen tow hook latches of either of the two pushplates and pushplate (s) in the direction to get move Download2007 Toyota Tundra mounting kit installation instructions
Posted in
Toyota
.
Bookmark the
permalink.
RSS feed for this post.