MainPage »
Toyota
»
2007 Toyota Fj Cruiser air dam/light bar installation
2007 Toyota Fj Cruiser air dam/light bar installation
internal installation of switch/wire harness () locate the vehicle, White 6-PIN connector behind the lower instrument panel. (Figure 2-1) (1) Note: connector of the vehicle will be wrapped in gray foam tape. (b) installation of remote time switch (Figure 2-2), in available knockout (location 1 or 2), and in the orientation shown. (Figure 2-1) (c), plug the 6-pin white connector in the key. (1) confirm the connector is firmly attached. (d) the removal of the driver and passenger side visors. (1) rotate and loosen shaft support visor from visor holder clips as shown. (Figure 2-3) (2) does not remove clips from popular actor. (e) remove the sun visors (Figure 2-4) (1) remove the two Phillips screws (2) from the driver and passenger side visors.
To remove the driver and passenger side Assist grips. (1) remove the screw covers for all the claws four (4) assistance. (Figure 2-5) (g) remove the two (2) 10 mm hex head screws from the driver and passenger assist grips. (Figure 2-6) (h) "" pillar garnish to remove front passenger. (1) pull door seal around front "pillar". (2) places the two (2) videos and one (1) nail and remove the front pillar garnish. (Figure 2-7) (i) remove the front pillar garnish driver. (1) using the same procedure as the passenger's side. (j) to remove the mirror. (1) remove the mirror base mountain cover by careful insertion tool for Remove panel , as shown. Download2007 Toyota Fj Cruiser air dam/light bar installation
Posted in
Toyota
.
Bookmark the
permalink.
RSS feed for this post.