MainPage » » Volvo C70 transmission control module removal and installation

Volvo C70 transmission control module removal and installation

command module programming-read this first new transmission module (presura) is delivered without software. presura must be programmed to function after replacement. This requires the use of a tool for scanning the Volvo factory (Vadis), or equivalent. The software can be ordered only when the module is installed in the car. Vadis read outside the new identity of the management module. This is required so that the correct software can be ordered. Warning: wait two minutes after the ignition has been turned off before you remove the presura. before the module can be removed from the car, the main relay must be free. If the engine cooling fan is running on after the ignition is switched off, wait until it stops. then wait for a further 2 minutes. Caution: always check that the presura and presura connector pins and sleeves are not bent or damaged before replacing presura. This might have caused the fault. removal and installation 1. Move the shift lever Park (p) position. Turn off the ignition wait two minutes. 2. to remove the cover over the module on the right side of the engine compartment. control of transmission module (presura) is closest to the engine module. see Figure 11. Caution: do not touch the control module ensuring pin with fingers. static electricity may components of management module failures. 3. Insert instrument (999 5722), (1) around the module. see Figure. Move back the upper part of the instrument, as far as it will go (2). improvement of the tool. Carefully pull up on the control module. 4. gently press down in the grooves are a new module within the module control. Click to place the border! Insert tool 999 5722 around module. Move the upper part of the instrument next to stop and pull. Press the cover over the control. Check that the air ducts are position. 5. If you are installing new presura, programme of the new module for the management of the transmission. Check for dtcs, which may have been placed in memory during the repair.


Download


Posted in . Bookmark the permalink. RSS feed for this post.
Powered by Blogger.

Search