Free Online Manual

MainPage » hyundai » Wiring Connector Manual Guide Hyuandai ELANTRA CORROSION

---

Wiring Connector Manual Guide Hyuandai ELANTRA CORROSION

A facility leakage between the trickster outmost panel and cowl panels may resultant in corrosion of the proximity entranceway wiring connector pins if the object is operated in areas where means seasoning is utilized. The corroding may strike the cognition of the electrical circuits in the entryway, much as the speakers, nation windows, etc. To correct this status, reseal the seams and inspect the entrance wiring connectors for corrosion. If needful, position the entryway wiring connector and the entryway wiring by followers the couple procedures described in this TSB. SEALING THE Committee SEAMS: Comment: This sealing process applies to both nigh and modify sides.
1. Open the hood. 2. Locate the “A” pillar outer panel and cowl panel seaming area at the base of the “A” pillar. 3. Lift up the lower end of windshield glass molding to obtain space for sealant application. 4. Clean the sealant application area on both the left and right sides of the vehicle (fender removed in photo for clarity). 5. Apply clear sealant along the seam line between “A” pillar panel and cowl panel from the engine compartment as shown in the photo. 6. Use appropriate tool or finger (with rubber nitrate gloves) to smooth material to seal the sealant. NOTE: Apply enough sealant to completely fill the seam. Be careful not to drip excess sealant in the engine compartment or on the hood. – Photo shows panel seams where sealant is applied on left side. – Repeat for the right side. 7. Open the front door. 8. Apply the clear sealant to the seam between “A” pillar panel and the fender mounting bracket from inside the door opening. 9. Apply the clear sealant to the bottom of the fender mounting bracket and the top of the hinge. 10. Use appropriate tool or finger (with rubber nitrate gloves) to smooth material to seal the sealant. NOTE: Apply enough sealant to completely fill the seam. Be careful not to drip excess sealant on the door trim or in the interior. – Sealant is applied along the top edge of the fender bracket.

download from here