Note: the following procedures without first removing the ABS wheel speed sensor may lead to an open circuit in the wiring harness if it is filed in error. Before you perform the following procedures, disconnect the ABS wheel speed sensor connector (shaft side) and fix the wiring corresponds to the place where he is not retrieved by mistake during maintenance of the car. 1. remove the in the specified table. 2. install in the reverse order of removal. 3. after installation, check the alignment of the front wheel and change it if necessary. (See front WHEEL alignment). LOCKNUT REMOVAL NOTE 1. Knock corrugated part locknut outwards using a small drill and hummer. 2. Locking hub by applying the brakes. 3. remove the locknut. BRAKE CALIPER REMOVE NOTE 1. Remove the brake caliper from the Steering knuckle and suspend it away using a cable. MOUNTED WHEEL, STEERING KNUCKLE COMPONENT DELETE NOTE 1. Single shock absorber, wheel hub from the Steering knuckle component by clicking the top of the Steering knuckle with a hammer. Download
