MainPage »
Kia
»
2010 KIA SOUL STILLEN Axel-Back uitlaat INSTALLATIEINSTRUCTIES
2010 KIA SOUL STILLEN Axel-Back uitlaat INSTALLATIEINSTRUCTIES
Note: this system is designed to use the stock hanger locations. Check the alignment of your OEM-system before the installation. If the tips of your OEM-system not straight or centered in the rear valance, then the replacement system will also be aligned. Removal of the O.E.M. system: 1. parking of the vehicle on a smooth level asphalt or concrete surface and set the parking brake firmly. Place a block in front of and behind the front wheels. Jack-up of the rear of the vehicle and place on jack stands under the frame in the manufacturers specified locations. On the other hand, would be best that the vehicle raised at a hydraulic elevator. Warning: do not work under a vehicle stopped only by a jack. Place jack safely under the vehicle manufacture in the specified location. 2. Spray all the rubber rings with a spray lubricant to ease of removal of the system. 3 see (fig. 1). Remove the 2 notes on the flange. Pull the exhaust of the pendants. See (fig. 2) 4. You will then the black cover that relate to the bumper to make the cut for the tip exhaust. You will get different screws holding the of under/back of the bumper. See (fig. 3) 5. The reflectors unlock by removing the screw keeps them this will be needed to access the 2 inner screws on the black cover. Figure 4 Behold (fig. 4) they easily pop out the screw is removed. Carefully set aside. 6. When the reflector is removed you must unscrew the upper part of the bumper black cover where shown Fig. (5) there is 1 screw company every corner of the upper black cover. Reserved as they will be reused. Figure 5 Download
Posted in
Kia
.
Bookmark the
permalink.
RSS feed for this post.