Free Online Manual

Mazda 3 smoked rear reflector with instructions on how to install LEDs

1) Remove covers on either side of the hatch. (see below) 2) to remove the nuts that provide rear tail lights, use a 10 mm socket (with the extension). (right) 3) remove both rear tail lamps. This may require a small amount of power, as the plastic ball/socket joints that hold the headlight in place. Once the tubes are free of charge, disconnect the wiring from the power of the bulb. (right) 4) use a flat head screwdriver to remove the large locks that provide rear bumper car. They are difficult to remove. (left) 5) using a Phillips head screwdriver to remove the locking rear bumper for wings. The screws are located just above the rear bumper where the wheel meets the fender. (right) 6) using a Phillips head screwdriver to remove the locking rear bumper from the wheel well liner. The screws are under the car at the rear wheel wells. (left) Download