Free Online Manual

1998-2005 Audi C5 ramparts and regulators camshaft installation and removal

Delete remove toothed belt camshaft chain = > page 13-19. Remove the camshaft wheels from the Bank cylinder 5-8. Loosen the bolts to -1-. Remove the screws -2 and toothed belt cover. Remove the lid of the cylinder = > 15-2 page. Remove the camshaft position sensor (CMP), para. -30 and CMP rotor, para -27-= > 15-35 pages. Check the TDC position pushers: both markings on pushers should be brought into line with arrows on the bearing caps. When reusing the chain drive: clean drive chain and camshaft wheels. Mark position with paint. ATTENTION! Not to celebrate the chain with a kick or engraving, using only paint. Continued safe camshaft regulator with bracket for chain tensioning tool 3366. ATTENTION! Do not over tighten bracket for chain tensioning tool, or camshaft adjuster may be corrupt regardless of marked relevance hats, mark sequence and position all the bearing cover, as shown in the figure. Remove the screws for the camshaft control-arrow-. Remove the cover value of 0. Remove the caps 1, 3, 5, 7 and 8 and place in order to clean the surface. Loosen the bearing caps 2, 4 and 6 on the diagonal and delete. Remove the ramparts with camshaft control. Camshaft installation in control backward delete but note the following: replace the semicircle Cap.

Download