Free Online Manual

BOOSTZILA Super Charging System for the Acura/Honda NSX Installation

Preparation Steps for Fuel System Installation
A: Adjust both seats to full forward position with seat backs in full upright position.
B: Disconnect the negative battery cable.
C: Remove the 5 rear interior panels starting with the long piece across the width of the car just beneath the rear glass. Next remove the two flat panels located behind the seats. Next remove the two corner pieces. Lastly, remove the rear center speaker and cover assembly. (The long panel across the width has 3 push lock barbed style securing pins w/one on each end and one in the center) (The 2 flat panels have 4 push lock barbed securing pins each, w/each barb located a couple of inches from each corner of the panels) (The corner sections are held in place with 3 Philips screws which become exposed after the flat panels are removed)
D: Remove the engine cover.
E: Remove the strut brace from the engine compartment.
F: Remove the stock air box assembly.
G: Remove the fuel rail covers, the engine name plate cover, and the intake manifold metal cover.
H: Carefully raise car using an automotive lift. If no automotive lift is available use a floor jack. If using a floor jack raise the vehicle as high as possible to safely get 4 jack stands under the unit body in the appropriate factory recommended positions. The car must be high enough to remove the fuel tank.
I: Remove the rear wheels at this time.
J: Relieve the fuel pressure in the fuel tank by loosening the gas cap.

Download